Products

 

Contact Us

Hackney Service Vehicles
911 West 5th Street
PO Box 880
Washington, NC  27889

1-800-763-0700
1-252-946-6521
1-252-975-8340  Fax

Email Hackney Service Vehicles

Drain Cleaning - p/2000 Jetter

Standard Specifications

Overall Dimensions
Width 84” (90” W optional)
Length 12’ 6” (14’ & 16’ optional)
Headroom 75”
Aisle Width ~ 35”
Height from Ground ~9’ 4” diesel / ~9’ 6” gas (loaded)
Chassis (see chassis requirements)
GVWR 12,000 lbs. to 14,500 lb  
Low Cab Forward Design Diesel 109” WB / 87” CA
Conventional Cab (CV) Diesel ~84” CA (requires 90” W body)
Standard Equipment
Roof Double wall with insulation, aluminum exterior / white panels interior
Floor Aluminum interlock planks – drop in rear for walk-in access
Insulate under floor
Sides & Front Double wall aluminum
Add wall plate on curbside
Rear Aluminum step type rear bumper with open safety grating
  Aluminum diamond plate scuff panel above bumper
  Cast aluminum recessed license plate holder with light
  Mud flaps
  Add plate over stepwell each side in rear
Doors Full width double swing-out rear door– 79” H x 73” W – double wall aluminum
  HD deadbolt lock with deluxe handle & push cylinder
  Spring rod door retainers to hold doors 90 degrees out
  ROM side roll-up door curbside for Jetter access - 33” W x 36” H.
Interior Shelves 38” open space across front for jetter mount
  Drivers Side: (1) 18” W section - 7 shelves high, (2) 36” W sections - 5 shelves high, (1) 24” W open section in rear.
  Curbside: (1) 36” W section - 4 shelves high, (1) 54” W section - 2 shelves high, (1) 24” W open section in rear.
  Full length pipe and ladder shelves at top on each side (total 4)
Interior Lights (3) Round clear overhead dome lights with switch at rear & master over-ride in cab
Paint One color white to match cab
Chassis Alteration and Mounting Drop frame behind rear axle for lower rear entrance, walk-in access
Hackney reserves the right to make changes on standard and optional equipment at any time without prior notice. All available options and standards are not listed. For more information please contact a sales representative.